Since writing my last article about the advantages of understanding the CTX 3030 to get the best out of it, I have spent many hours using the CTX 17 coil to see if adjusting the volume gain would make much difference. To my surprise and delight I have had some awesome results going over ground at the beach, parks and ovals that I had previously hunted with the CTX 11 coil. My first couple of weeks was 90% beach hunts with the best results coming from my settings at:
- Discrimination - full open screen with just the bottom line discriminated out
- Volume Gain - at maximum so that all targets would be at the same volume regardless of depth
- Seawater – on
- Recovery Fast – on
- Response – Long, because this allows you to hear the corroded and deep targets better.
The CTX 17 coil is massive and a bit heavier to get used to, but there are a couple of ways around this to save your shoulders and back. First thing is to use the new PRO-SWING 45 harness which makes a huge difference, straight away transferring the weight from your shoulders and neck and distributing it across your body.
Secondly for all those who have swung the CTX 3030 and noticed how well balanced it is with the CTX 11 will straight away notice a bit of obvious forward weight when running the CTX 17. I actually combated this by adding a bit of counter weight to the battery area, this helped to even things out and bring the unit back into balance making swinging easier.
The advantages of swinging the 17-inch coil were immediately noticeable. I was now able to cover so much more area during the lowest point of the tide (usually only about an hour), which increased my number of finds straight away. The best thing was how much more clarity & depth I was getting with this monster of a coil.
My first day at my local beach netted me 2 gold rings, 2 silver rings, a chunky silver bracelet and pocket full of coins. I found another ring the following day and many more great finds on the beaches since maximising the ability of the CTX 17 coil and the CTX 3030.
Happy swinging,
Mark Williams
www.coinrelicdownunder.wordpress.com
Comments
To make comments you must be logged in, please note comments will not display immediately due to moderation
Again a very interesting article regarding the CTX 3030. Next week i will order the 17 inch coil so i can test your settings on the beach in Holland.
I have a few questions for you, i hope you have some time to answer them. What target separation are you using? low trash/high trash/ferrous coin or ground coin? Do you run the programm in auto or in manual?
How do you recognize the gold targets because i am totally lost. Very old copper coins show like 12.29/ 12.36/ 12.40/ 12.42/ 12.43 etc and come alot of times together with a very sweet sound. The modern coins i recognize by reading the target id. The sound can be sweet hitting a deep target,but can be also very loud and almost too loud finding it just below the surface. A 2 Euro coin for example is always showing me like a 12.27. It's not a 100% score but the chances are very good finding one. This is not happening with gold. Very Good id number ( like 12.03/ 12.12, 12.18 ), nice sound, but ending up with trash. Is there a better way i can separate the trash from the golden goodies? I know it can be very hard, but maybe i am missing something here.
thanks again.
Regards,
Pepijn Hauwert
pepijnhauwert@hotmail.com
http://coinrelicdownunder.wordpress.com/