FBS 2
FBS 2 combines Minelab's FBS multiple frequency rectangular-wave transmission (1.5 kHz –100 kHz) with advanced digital coil-to-detector communications. The precisely calibrated smart coils and detector electronics allow advanced signal analysis for more accurate detection.
Smartfind 2
Smartfind 2 greatly enhances Minelab's FeCo Discrimination to analyse and display a target's Ferrous (Fe) and Conductive (Co) properties on a full colour LCD.
Ultra-fast microcontrollers carry out digital signal processing to provide significantly improved target separation.
GPSi
GPSi uses the high performance and flexibility of a u-blox GPS positioning engine to seamlessly integrate location and time data with detector settings and target information. This creates WayPoint, FindPoint and GeoHunt files that are compatible with XChange 2.
Wi-Stream
Wi-Stream uses efficient low-power digital audio transmission to achieve no perceivable audio time lag (<10 ms) between the Wi-Stream enabled detector and the WM Wireless Module. With multiple channel capability, this wireless technology provides reliable communication with maximum sound quality.
Wi-Stream technology is offered in a range of Minelab detectors, however the WM modules are not cross compatible between detectors.
WM module and detector compatibility:
WM 12 - GPZ 7000
WM 10 - CTX 3030
WM 08 - EQUINOX Series
Application
Coin, Relic, Jewellery & Beach (waterproof 10ft)
Technology
FBS 2, Smartfind 2, GPSi, Wi-Stream
Frequency/Transmission
Multiple frequencies: 1.5 - 100kHz
Coil (standard)
11-inch waterproof Double-D smart coil
Audio Output
Built-in speaker, standard ¼-inch non-waterproof socket, custom waterproof socket (Minelab accessory headphones only)
Headphones Supplied
KOSS UR30 (100 ohm) supplied with detector (non-waterproof )
Visual Display
Full colour LCD with backlight and adjustable brightness (1–10)
USB Connectivity
USB interface for XChange 2 PC software
Memory
Settings saved automatically while detecting and remain until changed or reset
Depth Indication
Accurate gauge active in normal detecting and Pinpoint mode
Detect Modes
10 fully customisable, including 5 preset (Coins, Beach, Relic, Silver & High Trash)
Discrimination
Smartfind 2TM 2 dimensional colour discrimination: Ferrous 35, Conductivity 50 - 20 fully customisable discrimination patterns (2 per Search Mode)
Audio tone
Customisable Tone ID Profiles - 1, 2 ferrous (Fe), 2 conductive (Co), 4 Fe, 4 Co, 35 Fe, 50 Co or Combined
Audio Type
Normal, Long, Smooth & Pitch Hold
Ground Balance
Auto Compensation and Auto Ground Balance
Pinpoint
Non-motion with modulated audio and visual crosshair on LCD, 2 modes: normal and sizing
Sensitivity Adjust
Auto and Manual (1–30)
Tune / Noise Cancel
Manual & Automatic (11 channels)
Threshold
Level adjustment (1–50), Pitch adjustment (1–30)
Target Volume Adjust
Limit & Gain (1 to 30)
Battery
Li-ion pack with fast charger. 12 V car adapter supplied with Standard Pack only
Low battery alert
Audio & visual indication.
Length
Min 37 in. (940 mm) – Max 55.3 in. (1405 mm)
Weight
5.20 lbs (2.36 kgs) including Li-ion battery pack
Warranty
3 years control box & coil
