The CTX 3030 incorporates four different Target Separation options... Low Trash, High Trash, Ferrous-Coin and Ground-Coin. Selecting the proper Target Separation option will allow you to optimize the signal processing of your CTX 3030, to best match your site.
Low Trash Target Separation should be used in areas with low to moderate levels of mineralization and minimal amounts of metallic trash. When passing over multiple targets in “Low Trash”, the CTX 3030 will respond to the target providing the strongest target signal, possibly masking a smaller adjacent target. Therefore, it is not recommended to use “Low Trash” in areas with a high concentration of metallic targets. In areas with lesser amounts of metallic trash, “Low Trash” allows the CTX 3030 user to create a very narrow discrimination pattern, based on accepting only the target property values you wish to hear.
High Trash Target Separation can be used effectively in areas with low to moderate levels of mineralization. “High Trash” implements advanced signal processing which recognizes accepted targets, even if the rejected targets are providing a stronger target signal. “High Trash” also allows the user to implement a faster sweep speed, and an aggressive amount of discrimination. These can become very important factors when you have a large amount of ground to cover, in a relatively short period of time.
Ferrous-Coin Target Separation provides an extremely stable Target ID for those detecting in areas of low mineralization. And it does an amazing job of sorting out coins from the ferrous trash. The advanced signal processing of “Ferrous-Coin” minimizes the blending of ferrous trash and coin type targets, even when directly adjacent or stacked.
When the coil passes over multiple targets simultaneously, each target will be identified and their FE/CO “locations” will be displayed as cursors on the color LCD screen. If the targets are within the accepted range of your discrimination pattern, (as a ferrous target would be when hunting with minimal discrimination) the Target ID will display the value of the coin type target(s).
Ground-Coin Target Separation is designed for use in areas with high levels of mineralization. Highly mineralized ground will typically “splatter” the Target ID values of coin type targets. When selecting “Ground-Coin”, the advanced signal processing of the CTX 3030 minimizes the blending of ground and coin signals, resulting in a more accurate Target ID. In areas of very high mineralization, enabling ground balance on your CTX 3030, combined with Ground-Coin Separation, will offer more Target ID stability with less ground noise.
NOTE: Highly conductive targets, such as US silver dollars, can give different target ID’s depending on which Target Separation feature is used. So make sure you familiarize yourself with the Target ID numbers representing targets you seek, to avoid walking away from what could have been “the find of a lifetime”.
Randy Horton (Digger)
You'll never know for sure......unless you dig it!
Comments
To make comments you must be logged in, please note comments will not display immediately due to moderation
Thanks again, the Niffler
I live in Australia and have been going around a few old battery mining sites. I've had moderate success with a few coins, buttons and other stuff. The areas are littered with nails and other metal and I just cant seem to get my settings correct.
I've been using the coin setting and modifying it a bit
Do you have any advice or suggestions on settings that I could try
The description reads
The advanced signal processing of “Ferrous-Coin” minimizes the blending of ferrous trash and coin type targets, even when directly adjacent or stacked.
However the X in the diagram is selected under Non FE Clutter??